Table of Contents
Advertisement
Maintenance (continued)
Remove/Reset devices from a group – safe mode
Purpose:
When the smartphone used to commission system is not available, components cannot be removed via the standard
method. Instead, components shall be reset via the Safe Mode.
How to:
The luminaires must be powered ON for more than 15 seconds.
• Power OFF mains for more than 10 seconds but less than 15 seconds (disconnect device from mains).
• Power ON mains for more than 2 seconds but less than 10 seconds (reconnect device to mains).
• Repeat above process for 4 times.
• On the 5th cycle, leave the fixtures powered ON at the end. You should see a short dim-down/dim-up signal.
Sensors are now in Safe Mode.
• Scan with "Device Maintenance" to discover the sensors that are now In Safe Mode and Reset them, see
screenshots below:
Click on three lines in
the right-bottom
corner
Click on "Reset"
PLt-20022UM - EasySense MasterConnect User Manual 09/22 page 22 of 43
Click on "Settings"
Click on "Device
Maintenance"
App will start
looking for devices
Click on "Select all"
If Reset was
If you want to add a
successful, no devices
light in a group, they are
in Safe Mode are
visible now
found (If devices are
still visible: press
"Reset" again)
Advertisement
Table of Contents
