Table of Contents
Advertisement
Commissioning (continued)
Grouping
Flashlight (Torchlight) commissioning
Purpose:
Add a device to a group using a flashlight.
How to:
• Point a flashlight to the desired device sensor to add to a group.
• The smartphone responds to detection of light with a sound and a brief vibration. Now the BLE connection starts
to setup. On the 2nd beep, the triggered light dims down. In the app, the selected light shows up with its Zigbee
address and the number of added luminaires is increased by 1.
• Go to the next light to be added to the group and repeat the process.
• When all luminaires for a group have been selected, choose "Finish adding." The number of devices that are bind
to that group are now displayed in the group overview.
Remarks:
• Use a flashlight/torchlight with a well-defined light cone and point to the sensor from 3cm - 5cm distance only to
cause a steep light increase.
• Typically illuminance of the sensor should increase by ≥ 5000lx suddenly. A 500 Lumen flashlight is recommended
(for SNH211 MC, a 1200 lumen or higher flashlight is recommended).
• It is required to wait for 2 beeps, after which a light will show up in Added menu. Wait for another 3 seconds before
proceeding to the next light.
• In case a light is not added with the flashlight, please re-try.
• If light remains unreachable, it might be that it was not in the scan list because of a too big range, e.g. in case of a
long corridor. A re-scan of the lights with closer range is required to add this light to the list. See "How to:" on page 6.
• It is strongly recommended not to change the flashlight sensitivity in the App settings section.
PLt-20022UM - EasySense MasterConnect User Manual 09/22 page 8 of 43
Advertisement
Table of Contents
