Table of Contents
Advertisement
Commissioning (continued)
Adding switches
Purpose:
A wireless Zigbee Green Power (ZGP) switch can be added to a
group or zone for lighting control.
How to:
• Choose "Switches" on the page of a group that needs to be
configured, "+" and again "Switch." From the drop-down list of
compliant switches, select the brand of switch you'd like to add
and indicate whether you would like to add to a zone or to the
whole group.
• Follow the switch commissioning instructions available on the
App or our website. Please follow the instructions carefully, e.g.
press the right buttons and don't press sequences too fast.
Once commissioned, the app requests to test if the switch
works correctly. Test the switch by making another button
press, and once it works as expected, press "Everything is fine."
• Please take note of the important remarks below.
Remarks:
• Add all luminaires in a group first and then add a switch. Switch
binding mechanism is to each node within the Zigbee group at
the time of commissioning. If new nodes are added after
commissioning, switch binding does not take place.
• A switch can be added either to a group or to a zone. Once
added to a zone, another switch will need to follow the same
choice i.e. either a group or a zone.
• Please refer to the device/sensor data sheet for the maximum
number of switches per group or zone. Combining switches
from different brands is not recommended.
• In case switches are used for a group and for zones of that
group, three things need to be taken into account:
• 1. The switch of the group should be added first.
• 2. Only 2-button switches should be used for the group.
• 3. In the zones, 4-button switches with scene setting can be used.
It is recommended to use not more than one 4-button switch
per zone.
In case the switch is not detected during the commissioning
procedure, please re-try.
PLt-20022UM - EasySense MasterConnect User Manual 09/22 page 17 of 43
Advertisement
Table of Contents
