Programming The Remote To Control An Auxiliary Component - ProScan PSVR71 User Manual

Program the Remote
Programming the Remote to
Control an Auxiliary Component
Your remote can also control the brands of the equipment listed, such
as a radio, CD player, tape player, or phonograph. It is already
programmed to control some ProScan and RCA amplifiers and audio/
video receivers.
1. Turn on the component to be programmed.
2. Look up your component's code number on the code list.
3. Press and hold the AUX button.
4. Enter the 4-digit code from the code list on the next page.
5. Release the AUX button and press ON•OFF or CHAN up or down
to see if the auxiliary component responds to the remote
commands.
Operating the Auxiliary Component
After you have programmed your remote, see which buttons will
operate your component.
1. Point the remote at the component and press AUX. If it does not
turn on, press AUX and then ON•OFF.
2. You may want to experiment to see which buttons will operate
your component. Try pressing buttons, such as play, REVERSE, and
FORWARD.
40
ON•OFF
AUX
REVERSE PLAY FORWARD
You'll use these buttons when you
program the remote to control an
auxiliary component.
Auxiliary Component Codes
ProScan/RCA/Dimensia
AM/FM
Auxiliary Component
Phono
Tape 1
This remote may not operate all
models of the brands that are shown.
0003
0004
0005
0006