Program the Remote
4. Repeat step 3 until the component turns off or you have
searched through all of the codes.
To cancel Code Search, press and hold CLEAR until the LED
turns off.
There are 20 total sets of codes. If the device does not turn off
after pressing PLAY 20 times, the remote cannot control that
particular component.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait two seconds. Repeat this
step until the component turns back on. This means the remote
has identified the correct code.
2. To finish, press and hold STOP until the LED turns off.
Using Direct Entry
Direct Entry is another way to program your remote if the Automatic
Code Search is unsuccessful.
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component in the
code list on page 41.
3. Press and hold the button on the remote you want to program.
4. Enter the code from the list on page 41.
5. Release the button, and then press ON•OFF to see if the
component responds to the remote commands. If it doesn't, try
pressing the component button and then ON•OFF again.
6. Repeat these steps using the next code listed for your brand if
you get no response.
Operating Components
After programming the remote, see which buttons operate your
component.
1. Point the remote at the component, and press its corresponding
button on the remote.
2. Experiment to see which buttons operate your component. Try
pressing buttons that relate directly to the component.
This remote may not operate all
models and/or brands of components.
Note the difference between the VCR
and other component's on-screen
displays to determine which one the
remote is operating.
39
Need help?
Do you have a question about the PSVR71 and is the answer not in the manual?
Questions and answers