Use Setup Menu To Auto Clock Set; Use Setup Menu To Auto Channel Search; Set Up Vcr Plus+ Channels - ProScan PSVR83 User Manual

Setting Up the VCR

Use SETUP Menu to Auto Clock Set

If the AUTO CLOCK SET was unsuccessful:
1. Press 1 to display the set time and date screen.
2. Enter the time and date with the number buttons on the remote.
Press 0 before single-digit numbers.
Example: press 0, then 5, then 0, then 7 for a time of 5:07. Press 1 for AM or 2
for PM.
Press CLEAR on the remote to change incorrect entries.
3. Press MENU¥PROG on the remote to remove the SET TIME AND DATE
screen from the TV screen and start the clock.
The time will appear in the VCRÕs display panel and the time and date will
appear on the TV screen when you press DISPLAY.
If you ever need to reset the clock:
1. Press MENU¥PROG on remote to display the VCR MAIN MENU on the
TV screen.
2. Press 3 to display the TIME menu.
3. Press 1 to display the set time and date screen.
If you set the clock manually, Auto Clock Set is switched to OFF.

Use SETUP Menu to Auto Channel Search

If you ever need to repeat Auto Channel Search because you change cable or
antenna signals:
1. Press MENU¥PROG on remote to display the VCR MAIN MENU on the TV
screen. If this menu does not appear:
Make sure TV is tuned to same channel as the CH3 CH4 switch on the back of
the VCR or the TVÕs video input (refer to TVÕs manual).
Press VCR1 (VCR2¥DVD), then press MENU¥PROG again.
If you use a basic hookup, check VCR indicator in display panel--it should
be on.
Check the connections.
2. Press 4 to display the CHANNELS menu.
3. Press 1 to begin Auto Channel Search.
The VCR automatically selects the Signal Type: Cable (cable-TV) or ANTENNA.
If you need to change the setting manually, press 3.

Set Up VCR Plus+ Channels

The VCR must be set up with the VCR Plus+ channels before you can record using
VCR Plus+. This can be done now or at a later time.
Press 1 if you would like to set up the VCR Plus+ channels now.
(Details are on page
Press 2 if you wish to skip this step.
16
38.)
SETUP
The Auto Clock Set
was unsuccessful.
Would you like to set
the time and date?
1 Set Time and Date
2 Skip this step
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
TIME
1 Set Time and Date
SET TIME AND DATE
Time --:--
(hh:mm)
Date --/--/--
Press MENU to exit
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Setup
6 Preferences
7 Language/Langue
8 Audio
0 Exit
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 VCR Plus+ Channel List
5 Cable box Setup
6 DSS Setup
0 Exit
SETUP
Would you like to set
up the channel lists
for the VCR Plus+
feature?
1 Set up VCR Plus+
2 Skip this step