General Information; General Instructions; Important; Risks - Vexve Hydrox HCU Remote Installation, Operation And Maintenance Instructions

2. General information

2.1. General instructions

These instructions contain information relating to
the installation of HCU Remote and its handling
in order that the functionality and safety are en-
sured. For situations not covered by this manual
please contact Vexve Oy. The manufacturer
reserves the right to make technical changes
and improvements. This instruction manual
assumes that the user is thoroughly familiar with
the control unit and its components. Installation
of the control cabinet and related work should
be carried out by a professional.

2.2. Important

Before the system is taken into operation, the
following items should be taken into considera-
tion:
· Make sure that the hydraulic system is not
pressurised, and power is turned off before
any work is carried out to the control unit or
its components.
· Do not ever leave any part of the hydraulic
system open to contamination to prevent
damage to the internal components.
· The HCU Remote warranty period is one year
from installation date. (The installation must
be carried out within six months from the
acquisition date. The control cabinet should
be stored according to the instructions)

2.3. Risks

HCU Remote can be used only if the control
cabinet is properly installed and serviced by a
professional. The control cabinet user should be
thoroughly familiar with these instructions. These
instructions are in addition to existing regulations
at the customer's premises regarding electric-
ity, pipelines and work. It is also essential to use
proper tools and safety equipment.
www.vexve.com

2.4. Handling

2.4.1. Delivery inspection

· Examine the control cabinet to ensure that
it, or internal components have not been
damaged during transport.

2.4.2. Storage instructions

· Protect the internal parts of the cabinet
from dirt, dust, water and moisture or other
contaminants.
· When the cabinet is supplied with a heater/
cooler and either of these cannot be
installed immediately, the cabinet should be
stored at room temperature. This will avoid
condensation/overheating which could
damage electronic components.
· If the control unit is installed and it is
not possible to connect power supply
immediately, electricity should be applied to
control unit for a while before operating any
valves in order to heat up/cool down the
components before use. Vexve does not take
responsibility of any damage to the control
unit resulting in the missing power supply in
outside environment.

2.4.3. Preparations before installation

· Make sure that the hydraulic connections are
clean.
· Check that all electrical connections are
intact.
7