Closing The Valve; To Stop Valve Moment; Local Control Buttons; Remote Control Buttons - Vexve Hydrox HCU Remote Installation, Operation And Maintenance Instructions

5.2.3. Closing the valve:

1. Once the valve is selected, press the CLOSE button.
2. The pump starts to close the valve according to the configured operational behaviour
curve. (see section 7.2.3).
3. The pump will automatically stop when the valve reaches the closed position.
5.2.4. To stop valve movement
1. If you wish to stop the control process, press the STOP button.
2. The valve stops at its current position until a new signal is given (OPEN/CLOSE)*
*Hydraulic actuators, which are equipped with a control block.
5.2.5. Local buttons
In the case of local control, the OPEN/CLOSE/STOP buttons are physical and look as shown in figure 4.
OPEN
VALVE
Figure 4. Local buttons

5.2.6. Remote control buttons

In the case of remote control (WebApp VPN), the OPEN/CLOSE/STOP buttons are virtual and look as
shown in figure 5.
www.vexve.com
Open
Figure 5. Remote buttons
CLOSE
VALVE
Close Stop
STOP
15