Step 3. Modify Network Parameters - Larson Electronics IDCMR-IP-POE-4MP User Manual

Step 3. Modify Network Parameters

1. In the list of devices discovered, find the device you want to change the network settings for, click the select
box to check it, and then see the Modify Network Parameters window. See below.
2. In the Modify Network Parameters window, edit the correct network parameters, and then enter the admin user
password in the field at the bottom.
a. Enable DHCP: You can select Enable DHCP to acquire compatible network settings from a DHCP server
installed on the LAN. However, these settings can be changed by the DHCP server. Since it is
recommended to use a static IP address, you can use DHCP to acquire compatible network settings, and
then uncheck Enable DHCP and save that configuration to retain the new network parameters.
b. In the example below, the IPv4 address was changed to 192.168.3.100, and the IPv4 Gateway was
changed to 192.168.3.1. These settings were determined to be compatible with the network switch and
other devices that share the same network.
3. Click Modify to save your settings.
Larson Electronics, LLC
Phone: (877) 348-9680 Fax: (903) 498-3364
IP Camera Network Setup Guide
www.larsonelectronics.com
7 of 10