Larson Electronics IDCMR-IP-POE-4MP User Manual page 10

b. In the message bar at the bottom of the screen, click Run. Follow the on-screen instructions to install
WebComponents. When the following screen opens, click Finish.
The Live View screen with the camera video image should appear.
For more information about the IE browser interface to your camera, go to LarsonElectronics.com for the latest IP Camera
User Manual for your camera.
NOTE: Most IP cameras have a Reset button for returning the camera configuration to its factory settings. The reset
button needs to be pressed with the camera disconnected from power. Continue holding the reset button down and plug
the camera back into power and continue to hold the reset button for an additional 30 - 45 seconds.
NOTE: For more details on using the functions of this camera, refer to the instruction manual for the Camera Management
Software (CMS) you are using.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
AT 1- FOR FURTHER ASSISTANCE.
877-348-9680
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.
Larson Electronics, LLC
Phone: (877) 348-9680 Fax: (903) 498-3364
IP Camera Network Setup Guide
SALES@LARSONELECTRONICS.COM
www.larsonelectronics.com
OR BY PHONE
10 of 10