Larson Electronics IDCMR-IP-POE-4MP User Manual page 5

Step 1. Install the SADP Software
1. Download the SADP Tool from the website: https://www.larsonelectronics.com/images/upload/SADPTool.zip. At
the time this document was published, the file is named: SADPTool.zip and is 115 MB.
2. Un-zip the file on a computer with Microsoft Windows (Windows 7 or newer) that is connected to the LAN where
your camera is connected.
3. Run the file contained in the zip file: SADPTool.exe. Follow the on-screen instructions to install the file.
NOTE : Be sure to allow the software administrative access or it will not work properly.
4. Open the SADPTool application. When the application opens, it automatically "discovers" and lists all compatible
devices on the LAN. The discovery of devices can take several minutes. See below.
Step 2. "Activate" Inactive Camera
NOTE: Cameras are activated when shipped with the default IP Address of 192.168.3.xxx. The last set of
numbers in your IP address will be random, but will always be in the 192.168.3.xxx subnet. Network settings
may be changed in the SADP Tool. See Step 3. Modify Network Parameters
When a camera is first installed, or reset to its factory configuration, it must be "Activated" before it can be used. In the
SADP Tool, "Inactive" devices have a Security status of Inactive. A device is "Activated" when a password is
assigned to the admin username of the device.
In the example below, a camera is activated and configured for its network.
Larson Electronics, LLC
DEFAULTS: Username: admin
Phone: (877) 348-9680
Password: 12345abc!
Fax: (903) 498-3364
IP Camera Network Setup Guide
www.larsonelectronics.com
5 of 10