Table of Contents
Advertisement
should set that PoE port to Off.
To open the PoE panel, either:
Click
on the PoE status panel on the ACC ES Admin Web UI launch page.
l
Click PoE from the Dashboard navigation bar.
l
To...
See how much power is available to, and being used
by, connected devices.
Adjust the power used by each PoE port.
Tip: You can also use the Power bar to
remotely power cycle the camera. After you
set the Power setting to Off, wait for the
camera to power off then change the Power
setting to Auto or Manual.
Tip: Devices that support both PoE and PoE+
(802.3at) modes of operation can be forced
into non-PoE+ mode (802.3af) by using a
manual 15W budget.
Settings are not implemented until you click Apply.
After you click Apply, allow the system to reboot when the following message is displayed:
Applying changes may power-cycle PoE-powered devices.
The ACC ES Admin Web UI automatically refreshes the screen and displays the updated settings after the
new power settings are applied.
Assigning a PoE Power Budget
Do this...
Look at the two bars at the top of the panel:
The Budget bar indicates the total
l
amount of power budgeted for all
devices connected to the PoE ports.
The Consumption bar indicates the
l
actual amount of power currently used by
all the connected devices.
Use the Power bar for each port to configure a
PoE power budget:
Click Off to disable power output to the
l
port. When power to a port is disabled,
the port no longer outputs power but can
act as a standard network connection for
any device.
Click Auto to automatically output power
l
to the connected device depending on
its mode of operation.
Click Manual to enter a power budget
l
value in watts. Make sure the budget
includes potential power loss at the
cable.
16
Advertisement
Table of Contents
