Pelican StealthLite 2460 - 183 Lumens Flashlight Manual

CHARGING INSTRUCTIONS

To ensure long term performance charge battery for 24 hours or more before first use.

"Quick Charge" CHARGE TIME 3 TO 4 HRS.

1. Push the AC/DC Power Transformer plug into the Charger Socket (the transformer socket is located in a pocket in the base). Plug transformer into electrical receptacle. The LED should be SOLID GREEN.
2. Insert the flashlight into charger base until locked in position. The LED will pulse RED.
3. When the LED changes to SOLID GREEN the light is fully charged and ready to use.

"Slow Charge" CHARGE TIME 16 TO 18 HOURS (CAR, RV OR BOAT)

1. Push the cigarette lighter adapter (CAT #8056) into the vehicle's socket and plug the transformer into the charging base. The LED should be SOLID GREEN.
2. Insert the flashlight into charger base until locked in position. The LED will glow RED.

ON/OFF

Swing the switch lever to the right (light facing away from you) until light activates. To turn light off, swing the switch lever to the left (light facing away from you) until the light goes off.

BATTERY PACK INSTALLATION

1. Remove lens housing by turning counter-clockwise.
2. Remove the lamp and contact module.
3. Remove used battery pack and replace with a fresh battery pack. The battery pack has a plastic rib to ensure that it can only be installed one way.
4. Replace the contact module and lamp.
5. Replace lens housing squarely on threads and turn clockwise while pressing on the lens housing slightly.

ALKALINE BATTERY (OPTION)

Insert 4 AA cell batteries (2 in-line with + end up and 2 in-line + end down) as indicated on polarity sticker located on the inside of the light.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or an otherwise damaged o-ring or mating lens lip surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the o-ring sealing surfaces. KEEP THE THREADS, O-RING GROOVE AND INSIDE LIP OF LENS LUBRICATED WITH SILICONE GREASE.

Do not charge alkaline batteries.

LAMP REPLACEMENT

To replace the lamp module follow steps in the battery installation section as listed below:

To remove lamp module follow steps #1 and #2. To replace lamp module follow steps #4 and #5.

CHARGER BASE MOUNTING INSTRUCTIONS

The charger base can be permanently mounted using double sided tape (included) or with two #8 screws (not included).

VEHICLE INSTALLATION

The charger base can be permanently mounted in most vehicles and this operation should be performed by a professional auto technician.

When installing the charger, ensure that the DIRECT WIRING RIG is connected to an ignition keyswitch line. The high amperage draw of the charger may drain the vehicle's battery if connected directly to the battery.

PRODUCT SPECIFICATIONS

Lamp Type: LED

Battery Burn Time: 32 hours

Battery Type: 4.8V NiMH (4-cell)

Battery Brand: Use Pelican Cat. #2469

HYDROGEN GAS ABSORBER

Internal catalyst pellets, located on the lamp, are there to help absorb hydrogen gas that could possibly be emitted by defective, leaking, reversed polarity or heavily discharged batteries. If the pellets become lost or damaged, replace lamp immediately. If pellets become wet, let them air dry. Pelican Products assumes no liability for any brand of batteries which are defective or cause injury to anyone when used in any Pelican flashlight.

REPLACEMENT PARTS

(310) 326-4700 • FAX (310) 326-3311 • www.pelican.com