Advertisement
BATTERY INSTALLATION
- Remove lens housing by turning counter-clockwise.
- Remove the lamp module.
- Remove the battery tray.
- Remove used batteries and replace with fresh batteries in the tray as shown by the polarity icons molded into the base of the tray battery.
- Insert the battery tray into the flashlight with the two metal tabs facing outwards.
- Replace the lamp module.
- Replace lens housing squarely on threads and turn clockwise while pressing on the lens housing slightly.
ON/OFF
Turn the lens housing clockwise until light activates. To turn light off, back lens housing off counter-clockwise until light goes off. Continue to back off for approximately 1 full turn to eliminate possibility of light activating accidentally in storage. DO NOT OVERTIGHTEN.
SCUBA DIVING APPLICATION
(Follow these instructions whenever you replace the batteries) Check closely for cuts, scratches, or otherwise damaged o-ring or mating lens lip surface as this can cause your light to flood instantly under pressure. Remove any salt deposits, sand, dirt, and foreign matter from O-ring sealing surfaces. KEEP THREADS, O-RING GROOVE AND INSIDE LIP OF LENS LUBRICATED WITH SILICONE GREASE.
If light is not to be used for some time, remove batteries to prevent possible LEAKAGE AND CORROSION
PRODUCT SPECIFICATIONS
Lamp Type: LED
Battery Type: E93 1.5V Alkaline C-cell (3
REPLACEMENT PARTS
2001O-ring
Battery Safety Information
HANDLE AND STORE BATTERIES PROPERLY TO AVOID INJURY OR DAMAGE BATTERIES CAN BE DANGEROUS!
Most battery issues arise from improper handling of batteries, and particularly from the use of damaged or counterfeit batteries. Please review the information below to avoid serious injury and/or damage to your property.
Alkaline Batteries
- For those lights with hazardous location safety approvals for explosive environments please be advised that the safety approval is only valid for the specified battery type manufacturer and, where applicable, brand names that are displayed on the flashlight and/or instructions sheets that are supplied with the light. The use of other battery technologies may reduce the performance of the flashlight and will invalidate the safety approval.
- Always read the battery manufacturers recommendations for the appropriate use of the battery technology/brand prior to using the flashlight.
- When replacing the batteries:
- Replace all the batteries at the same time.
- Do not mix battery brands and old and new batteries.
- Always insert batteries correctly with regard to polarity (+ and -) marked on the battery and equipment.
- Do not change batteries in a hazardous location.
- Remove batteries from equipment if it is not to be used for an extended period of time.
Read This Notice Before Use.
Hydrogen Gas Absorber Pellets
Located inside the flashlight are catalyst pellets which are present to absorb hydrogen gas that could possibly be emitted by defective, leaking, reversed polarity or heavily discharged batteries. If the pellets become wet, let them air dry. Pelican Products assumes no liability for any brand batteries which are defective or cause injury to anyone when used in any Pelican flashlight.
Battery Replacement
Do not mix battery brands or use Nicad or Zinc Carbon Batteries. Do not mix old and new batteries. Replace all batteries at the same time.
DO NOT MODIFY THIS PRODUCT!
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the NEMO 2010 LED that isn't answered in the manual? Leave your question here.