Pelican NEMO 2410, 2410N - LED Flashlight Manual

BATTERY INSTALLATION

1. Remove lens housing by turning counter-clockwise.
2. Remove the lamp and contact module.
3. Remove used batteries and replace with fresh batteries as shown on the outside of the engraved body.
4. Replace the contact module and lamp.
5. Replace lens housing squarely on threads and turn clockwise while pressing on the lens housing slightly.

ON/OFF

Swing the switch lever to the right (with the light facing away from you) until light activates.
To turn light off, swing the switch lever to the left (with the light facing away from you) until light goes off.

SCUBA DIVING APPLICATION

Check closely for cuts, scratches, or otherwise damaged o-ring or mating lens lip surface as this can cause your light to flood instantly under pressure. Remove any salt deposits, sand, dirt, and foreign matter from O-ring sealing surfaces. KEEP THREADS, O-RING GROOVE AND INSIDE LIP OF LENS LUBRICATED WITH SILICONE GREASE.

If light is not to be used for some time, remove batteries to prevent possible leakage and corrosion.

PRODUCT SPECIFICATIONS

Lamp Type: LED
Battery Type: 1.5V Alkaline AA-cell (4)

REPLACEMENT PARTS

Read This Notice Before Use.
Hydrogen Gas Absorber Pellets
Located inside the torch are catalyst pellets which are present to absorb hydrogen gas that could possibly be emitted by defective, leaking, reversed polarity or heavily discharged batteries. If the pellets become wet, let them air dry. Pelican Products assumes no liability for any brand batteries which are defective or cause injury to anyone when used in any Pelican torch.

Battery Replacement
Do not mix battery brands or use Nicad or Zinc Carbon Batteries. Do not mix old and new batteries. Replace all batteries at the same time.
DO NOT MODIFY THIS PRODUCT!

Battery Safety Bulletin Alkaline Batteries

1. Hazardous location safety approvals for explosive environments are only valid for the specified cell type manufacturer and, where applicable, brand names that are displayed on the flashlight and/or instructions sheets that are supplied with the light.
2. The use of other battery technologies may reduce the performance of the the flashlight. Always read the battery manufacturers recommendations for the appropriate use of the battery technology/brand prior to using them in the flashlight.
3. When replacing the batteries:
   1. Replace all the batteries at the same time.
   2. Do not mix battery brands and old and new batteries.
   3. Always insert batteries correctly with regard to polarity (+ and -) marked on the battery and equipment.
4. Do not change batteries in a hazardous location.
5. Remove batteries from equipment if it is not to be used for an extended period of time.

PELICAN
23215 Early Ave.

• Torrance, CA 90505 USA

Tel (310) 326-4700

• FAX (310) 326-3311
• www.pelican.com

PELICAN^TM CANADA
10221-184 St.

• Edmonton, Alberta T5S 2J4 Tel (780) 481-6076
• FAX (780) 481-9586

2413-315-001 5-1441 Rev A © 2011 Pelican Products
All trademarks are registered and/or unregistered trademarks of Pelican Products, Inc., its subsidiaries and/or affiliates.

Videos

Pelican 2410N LED Flashlight - Overview Video

Documents / Resources

References

• Pelican

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Pelican NEMO 2410, 2410N - LED Flashlight Manual