Table of Contents
Advertisement
T1/PRI NAC
1 From the Main Menu, select option 5 <or 6>, Span Line 1 <2>
Configuration.
This screen displays:
Span Line 1 Configuration
1 Framing Mode
2 Line Coding
3 Remotely Initiated Loopback Ignore
4 Jitter Attenuation
5 Switch Type (Boot time)
6 Idle Byte Sent to TELCO
7 DS0 to Modem Slot/Chan Mapping
8 Signaling Channel Config (Boot time)
channel Act.=D-channel
9 Interface ID
10 Span Level Call Type Blocking
11 Span Level Cause Codes
12 DS0 Level Call Type Blocking
13 DS0 Level Service State
14 Short Haul NIC Line Length 0-133
(NOTE: Changing configuration parameters may effect calls in
progress.)
Enter menu selection and press Return or press Esc to exit.
Menu Selection (1-14):
2 Select option 14.
This screen appears:
T1 Span Line 1 Short Haul NIC Line Length
1 0-133 feet
2 134-266 feet
3 267-399 feet
4 400-533 feet
5 534-655 feet
Enter menu selection and press Return or press Esc to exit.
Menu Selection (1-5):
3 Type the necessary length and then press Enter to accept the value.
The default is 0–133 feet.
4 Return to the Main Menu.
Config=5ESS(AT&T)Act.=5ESS(AT&T)
Configuring Software
Current Setting
ESF
B8ZS
Receiver
FE Hex
Config=D-
0
No Call Blocked
3-5
Advertisement
Table of Contents
