Table of Contents
Advertisement
3-4
C
3: N
HAPTER
ETWORK
I
C
C
NTERFACE
ARD
ABLING
3 Type the necessary length and then press Enter to accept the value.
The default is 0–133 feet.
4 Return to the Main Menu.
5 From the Main Menu, select option 3, T1 Card Configuration.
This screen displays:
T1 Card Configuration
1 Save current Configuration to NVRAM
2 Restore NVRAM Configuration
3 Restore Default Configuration
4 Timing Source Priority Assignment
BUS=0
(NOTE: Changing configuration parameters may effect calls in
progress.)
Enter menu selection and press Return or press Esc to exit.
Menu Selection (1-4):
6 Select option 1 to save your configuration to NVRAM and then press
Enter.
The T1 Span Line Jitter Attenuation parameter found under option
5 <and 7> of the Main Menu (T1 Span Line 1 <2> Configuration), is
permanently enabled on the receive side.
Current Setting
T1-1=1 T1-2=2 INT=0
Advertisement
Table of Contents
