Character Pitch 15 Cpi; Character Set Select: International Languages - Printronix SL5000 Series Programmer's Reference Manual

Chapter 6
Configuring the Epson FX-1050 Emulation with Control Codes

Character Pitch 15 cpi

ASCII Code ESC g
Hex Code
Dec Code
Purpose
† Comment This command is not defined in Epson FX printers. It is included

Character Set Select: International Languages

ASCII Code ESC R n
Hex Code
Dec Code
Purpose
where:
166
1B 67
27 103
Sets character pitch to 15 characters per inch (cpi).
in this emulation for compatibility with the Okidata KX-P1180
printer. This command is available in all print modes except OCR
A and OCR B.
1B 52 n
27 82 n
Specifies a language overlay that prints the characters shown in
Table 20 when the specified code is invoked. Table 38 on page
160 provides information on print mode support for each
character set.
n = hex 0 through hex E to determine the language overlay
shown in Table 39 below. Epson only defines character sets
through hex C.