Adjusting/Calibrating Carburetors (2000) - Arctic Cat Bearcat 7000 XT 2017 Operator's Manual

Locate the coolant tank; then remove the
plug from the coolant tank. Add coolant
to the full level (COLD) on the tank.
Install the plug.
CAUTION
If the coolant is below the neck and if
coolant has been added, immediately
inspect for leakage and/or damage. If
leakage or damage is detected, take
the snowmobile to an authorized Arc-
tic Cat Snowmobile dealer for ser-
vice. If not under warranty, this
service is at the discretion and
expense of the snowmobile owner.
Adjusting/Calibrating
Carburetors (2000)
0747-547
The carburetors have been adjusted/cali-
brated at the factory for average riding
conditions; however, altitude, tempera-
ture, and general wear may necessitate
certain carburetor adjustments.
0749-003
For information on altitude operation,
see Varying Altitude Operation sub-
section in the Operating Instructions
section.
Carburetor adjustments critically affect
engine performance; therefore, the fol-
lowing three external adjustments and
two internal calibrations can be made on
each carburetor.
0747-766
Make sure to perform these adjust-
ment/calibration procedures on both
carburetors.

NOTE: The following external car-
buretor adjustments may be done by
the snowmobile owner if qualified to
do so. If the owner does not feel
qualified, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for this service. This service
is at the discretion and expense of
the snowmobile owner.
CAUTION
CAUTION
0745-141
37