Arctic Cat Bearcat 7000 XT 2017 Operator's Manual page 13

E. Service Icon
On electric start models, the icon should
illuminate each time the key is turned to
RUN or START, and it should go out
when the engine starts. If the icon stays
illuminated (on electric start models) or it
illuminates while the engine is running,
the system is receiving input that is out-
side of its established parameters. If the
icon illuminates indicating an error, take
the snowmobile to an authorized Arctic
Cat Snowmobile dealer for service. If not
under warranty, this service is at the dis-
cretion and expense of the snowmobile
owner.
F. High Beam Indicator
The indicator is on whenever the high
beam mode is selected by the headlight
switch.
Standard Gauge (3000/
7000)
1. Left Button - Shifts top display
through speedometer, and RPM.
2. Middle Button - Shifts middle dis-
play through speedometer, RPM,
clock, odometer, trip 1, trip 2, and
engine hours.
3. Right Button - Shifts bottom display
through coolant temperature, bat-
tery voltage, and fuel level.
4. Speedometer/Tachometer Display -
Indicates approximate vehicle speed
in MPH or KM/H when speedome-
ter function is selected, RPM when
tachometer function is selected.
Press the Left Button to change
which parameter is being displayed.
With speedometer selected, press
and hold the Left Button to shift
between standard (MPH/miles/Fahr-
enheit) and metric (km/h/kilometers/
Celsius).
5. Engine Hour Meter/Odometer/Trip
Meter/Speedometer/Tachometer/
Clock Display - Displays engine
hours, odometer, trip meter, speed-
ometer, tachometer, or clock. Press
the Middle Button to change which
parameter is being displayed. The
Engine Hour Meter and Odometer
cannot be reset. To reset the trip
meter, select the Trip Meter; then
press and hold the Middle Button
until the trip meter display reads 0.
With the clock mode selected, press
and hold the Left Button to set the
clock. The option of selecting the
12-hour or 24-hour clock is avail-
able; press the Left Button to alter-
nate between the two modes. Next,
press the Middle Button to set the
clock. Press the Left or Right to set
the hours; then press the Middle
Button to set the minutes. Press the
XM248A
Left or Right Button to set the min-
utes. When the proper time has been
set, press the Middle Button to
return to the main gauge display.
6. Coolant Temperature/Battery Volt-
age/Fuel Level Display - Displays
coolant temperature, battery voltage,
and fuel quantity. Press the Right
Button to change which parameter is
being displayed. Press and hold the
Right Button to see the actual values
associated with the mode selected.
7. Gear Position Indicator - Indicates
what gear the transmission is in.
8. Coolant Temperature Indicator -
When the snowmobile is started, this
indicator will flash and LOW TEMP
will be displayed until the engine
reaches operating temperature.
9