Table of Contents
Advertisement
4. Carefully trim the excess away from the
edge of the seal (B).
The brackets should be positioned only
after having placed the hob on the seal.
This kind of built-in application needs a milling
on the hob top of 3 mm in depth (detail "B" in the
picture above). Before positioning the
appliance, place the supplied seal (C) on the
milling.
Connection dimensions (mm)
Electrical connection
36 - INSTALLATION
Gas connection
Mounting
Over built-in oven unit
The clearance between the hob and the kitchen
units or other built-in appliances must be enough
to ensure sufficient ventilation and air discharge.
If installed above an oven, a space must be left
between the bottom of the hob and the top of
the appliance installed below.
1 Opens on bottom
2 Opens on bottom and back
On neutral compartment
If there are other pieces of furniture under the
hob, a double-layer wooden base must be
installed at least 20 mm from the bottom of the
hob to avoid any accidental contact. It must
only be possible to remove the double-layer
base using suitable equipment.
1 Opens on bottom
2 Opens on rear
A min. 10 mm - max. 50 mm
B max. 50 mm
C max. 50 mm
91477A898/A
Advertisement
Table of Contents
