How To Change The Filters; Cleaning With On-Board Tools - Carpet Pro CPU-250 Owner's Manual

Your vacuum cleaner is equipped with a secondary filter and a foam filter� These filters
capture fine dust particles and protect the motor from dirt� Accumulated dirt in the bag
compartment will be collected on the filters and may restrict motor performance� It is important
to change the filters regularly — approximately once a year or as needed�
How to Change the Secondary Filter
1� Unplug the vacuum cleaner� Remove the bag compartment cover and remove
the vacuum bag�
2� Remove the secondary filter by sliding it out from under the bag supporter (Fig� 1)�
3� Insert a new filter, replace the bag and bag compartment cover�
How to Change the Foam Filter
1� Unplug the vacuum cleaner� Remove the filter cover below the dust compartment cover
(Fig� 2)�
2� Remove the filter from the front of the vacuum (Fig� 3)�
3� Insert a new filter and replace the filter cover�

Cleaning with On-Board Tools

Your vacuum cleaner is equipped with on-board cleaning tools,
including a telescopic wand, stretch hose, dusting brush and a
crevice tool�
1� To use the cleaning tools, lift the hose handle straight up from
the vacuum (Fig� 1)�
2� Extend the wand by pulling the button back and pulling the
smaller wand out of the larger wand (Fig� 2)�
3� Attach any of the on-board tools to the end of the wand, or
if you do not need the wand, any tool can be connected
directly onto the hose handle�

How to Change the Filters

7
Fig� 1
Fig� 2
Fig� 3
Fig� 1 Fig� 2