Initializing The Transmitter For The Fi Rst Time - Napoleon Ascent BX42 Installation Manual

5.5 initializing the transmitter for the fi rst time
WARNING
!
• Ensure the gas and electrical power to the appliance is turned off.
A.
Locate the transmitter and receiver supplied with the appliance.
B.
Make sure the slide switch on the receiver is set to the "OFF" position.
C.
Press the battery compartment slightly into the receiver and release enabling the battery compartment to
pop out. (Fig. 1).
D.
Place 4 "AA" batteries into the battery compartment and slide the compartment back into the receiver.
(Fig. 2).
E.
Connect the receiver wires to the two leads from the control module, identifi ed as switch wires. See
"wiring diagram" section.
F.
Place 2 "AAA" batteries into the battery compartment of the transmitter (Fig. 3).
G.
Slide the switch on the receiver to the "REMOTE" position. The low battery indicator on the
receiver will fl ash and the receiver will beep twice. The receiver is now ready to communicate with the
transmitter. You only have 30 seconds after the receiver is put in the "REMOTE" position to
capture the code, which will be indicated by three beeps from the receiver.
H.
Point the transmitter at the receiver, push and hold the "ON" button for 1 to 2 seconds to capture a
predetermined code. The low battery indicator on the receiver will fl ash and the receiver will beep three
times to confi rm synchronization with the transmitter. At this time the remote should be fully operational.
BATTERY
INSTALLATION
BA T.L OW
STICKER
(See 7. FINISHING)
BATTERY
COMPARTMENT
FIGURE 1
RECEIVER
FIGURE 2
electrical information
TRANSMITTER
°F °C
AAA
AAA
BATTERY
COVER
FIGURE 6
EN
37
W415-2920 / B / 04.26.22