Top Exit - Napoleon Ascent BX42 Installation Manual

2.8

top exit

WARNING
!
• Failure to create a seal to the fi rebox with the exhaust collar assembly will cause the appliance to function
improperly and can cause injury or property damage.
note:
This appliance has been factory shipped as a top vent appliance.
A.
Remove the safety barrier and glass door (see "safety barrier & door removal / installation" section).
B.
Remove the contents from the fi rebox and set aside.
You will need the exhaust and air inlet collar.
C.
To ease assembly, remove the 4 hex head screws,
securing the defl ector from inside the top front of the
fi rebox (Fig. 1). Set defl ector aside.
D.
Remove the 1 1/2" (38.1mm) thick batt of insulation and discard (Fig. 2).
E.
Place the 8" (203mm) intake collar and gasket onto the top of the appliance and secure using 4 screws
(Fig. 2).
tip:
The manual baggie supplies the gasket and screws (packaged in another separate baggie).
1 1/2" INSULATION BATT
note:
Top baffl e must not be installed for top exit applications.
INTAKE
COLLAR
GASKET
venting requirements
DEFLECTOR
GASKET
OUTER
HEAT
COVERPLATE
SHIELD
Fig. 2
EN
Fig. 1
21
W415-2920 / B / 04.26.22