Remote Control Layout; General Transmitter Layout; Split Fl Ow (Gdix4 Only); Initializing The Transmitter / Battery Holder For The Fi Rst Time - Napoleon Oakville GDIG3 Series Owner's Manual

5.1

general transmitter layout

Transmission
Flame ON
5.2 split fl ow (GDIX4 only)
The split fl ow function controls the ability to turn ON /
OFF a second burner.
1. Use the mode key to guide you to the split
fl ow function.
2. Pressing the up arrow key will activate the
second burner.
3. Pressing the down arrow key will deactivate
the second burner. A single "beep" will
confi rm the reception of the command.
note:
This is no way to modulate the flame heights separately.
5.3 initializing the transmitter / battery holder for the fi rst time
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the reset/program button (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
Blower

5.0 remote control layout

Key Lock
Low battery alarm
Temperature
Split Flow
Light
76
°F
OFF
Room
CPI mode
76
°F
ON
TRANSMITTER
W415-1867 / B / 02.07.19
EN
11