Maintaining Transceivers And Optical Cables - Cisco Nexus 9508 NX-OS Hardware Installation Manual

Connecting the Switch to the Network
Step 3
Use the narrow end of the optics extraction tool to carefully remove the transceiver module (see the following
image).
Step 4 Place the transceiver module in an antistatic bag or other protective environment.

Maintaining Transceivers and Optical Cables

Transceivers and fiber-optic cables must be kept clean and dust free to maintain high signal accuracy and
prevent damage to the connectors. Contamination increases attenuation (loss of light) and should be below
0.35 dB.
Consider the following maintenance guidelines:
• Transceivers are static sensitive. To prevent ESD damage, wear an ESD-preventative wrist strap that is
• Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions
• Keep all optical connections covered when not in use. Clean them before using to prevent dust from
• Do not touch the ends of connectors. Touching the ends can leave fingerprints and cause other
• Clean the connectors regularly; the required frequency of cleaning depends upon the environment. In
• Inspect routinely for dust and damage. If you suspect damage, clean and then inspect fiber ends under a
Note
connected to the grounded chassis.
can shorten its useful life.
scratching the fiber-optic cable ends.
contamination.
addition, clean connectors if they are exposed to dust or accidentally touched. Both wet and dry cleaning
techniques can be effective; refer to the fiber-optic connection cleaning procedures for your site.
microscope to determine if damage has occurred.
If cable length is more than 5 meters, Auto Negotiation is not supported.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
Maintaining Transceivers and Optical Cables
47