Table of Contents
Advertisement
Replacing or Installing Modules, Fan Trays, and Power Supplies
a) Unscrew the screw on the center of each of the two handles on the fabric module. See Callout 1 in the following
figure.
1
Unscrew 2 captive screws (1 on each ejector handle).
b) Rotate the two handles at least 30 degrees so that the other end of each handle no longer holds the module in the slot.
See Callout 2 in the previous figure.
c) With each of the two handles in your two hands, pull the module a couple of inches (about 5 cm) out of the slot. See
the following figure.
2
Rotate both ejector handles away from the front of
the fabric module.
Cisco Nexus 9508 NX-OS Mode Switch Hardware Installation Guide
Removing a Fabric Module
91
Advertisement
Table of Contents
