Table of Contents
Advertisement
9. Electrical wiring
The installation of the Heatflow S5 requires a power outlet (120V). The wiring must be done
in accordance to local legislation/norms and national building code.
The wiring must only be done by a certified electrician.
The Heatflow S5 must be wired to a 120V/15 amp circuit breaker.
WARNING: Special attention must be taken to the passage of wires and should be shielded
from radiant heat. WIRES SHOULD NEVER BE IN CONTACT WITH ANY PART OF THE
SYSTEM (Stove, Heatflow S5 jacket, air conduit, pipe, etc ...)
Connect the blower to the control sub-assembly (G) with a 14/2 wire and wire connectors. The
following schematic shows how:
Installation Instruction HEATFLOW S5
WARNING
English
16
46310A
2023-05-25
Advertisement
Table of Contents
