Table of Contents
Advertisement
Note: The following image is to be used as reference only for a typical 3 air outlet system.
11.
Operating instructions
NEVER BLOCK ANY HOLES/LOUVERS ON THE HEATFLOW S5 METAL JACKET. FAILURE TO
COMPLY COULD RESULT IN FIRE, INJURY, DAMAGE TO THE STOVE, BLOWER OR AIR
DUCTWORK SYSTEM, etc..
DO NOT MODIFY THE SYSTEM. FAILURE TO COMPLY COULD RESULT IN FIRE, INJURY,
DAMAGE TO THE STOVE, BLOWER OR AIR DUCTWORK SYSTEM, etc..
ALWAYS SET THE SYSTEM TO "OFF" WHEN RELOADING THE STOVE WITH WOOD.
IMPORTANT : If the stove is new, it is normal to have an odor of smoke when lighting it for
the first time. This intitial fire(s) should always be done before connecting the air ductwork
system to the HEATFLOW S5 in order to prevent the odor of smoke from being dispersed to
all rooms having an air outlet.
1. Plug the control sub-assembly into an electrical outlet.
2. Select the desired mode with the 3 position switch located on the top of the control box behind the
HEATFLOW S5.
A- « AUTO MODE » in this position, the blower will
start and stop automatically with the temperature of
the stove.
O- « OFF MODE » in this position, the blower is
stopped immediately. It is highly recommended to
put the system in this mode when reloading the
stove with wood.
M- « MANUAL MODE » in this position, the blower
will always be energized.
3. Adjust the blower speed with the rheostat to optimise comfort at air outlet
a. Higher blower speed → Lower temperature at air outlet
b. Lower blower speed → Higher temperature at air outlet
Installation Instruction HEATFLOW S5
WARNING
English
19
46310A
2023-05-25
Advertisement
Table of Contents
