Table of Contents
Advertisement
14. Remove the pin (EE)
and latch mechanism
roller (FF) from the
handle shaft.
15. Remove
the
handle shaft (GG) and
replace it with the one
provided (M) with the
accessory. (The new
handle is longer.)
16. Put back the pin, its
roller and the small
spring pin. Adjust the
door latch mechanism
by
screwing/unscrewing
the
door handle
ensure a tight seal and
proper latching.
17. Verify the door seal by
closing and locking it on
a small piece of paper.
If the paper slips out
easily
anywhere
around the door, the
door adjustment must
be reviewed or the seal
gasket
must
changed. Once this is
done put back spring
pin (CC) to stop any
handle rotation.
Installation Instruction HEATFLOW S5
former
to
be
English
12
46310A
2023-05-25
Advertisement
Table of Contents
