How To Obtain The Fiery Password; Unlocking The Hdd - Canon imagePRESS P400 Service Manual

How to obtain the Fiery password

To log on to the imagePRESS Server as an administrator or operator, you must obtain the Fiery password.
To obtain the Fiery password
1. Make sure that the imagePRESS Server is connected to the printer.
2. Print the imagePRESS Server Configuration page from the display panel on the imagePRESS Server or the printer LCD
panel, see "To print the Configuration pages" on page
3. On the imagePRESS Server Configuration page, look for ID in the BIOS Setup section. The alphanumeric characters in the
ID field is the default password for the following:
• The administrator and operator password for the imagePRESS Server.
4. After you log on to the imagePRESS Server, change the Fiery password to prevent unauthorized usage.
NOTE:
Use Configure in WebTools or Fiery Setup Wizard to change the Fiery password.
Notes on the default password
• The Fiery documentation may mention "Fiery.1" as the default password. Do not use this password when you log on to the
imagePRESS Server for the first time. Instead, use the password obtained in Step 3 of "To obtain the Fiery password."
• If you reinstall the Fiery system software or restore factory default settings, the administrator password will be replaced by
"Fiery.1". Use "Fiery.1" to log on to the imagePRESS Server and change the password.

Unlocking the HDD

The HDD of imagePRESS Server is encrypted, by default.
NOTE:
HDD Lock is not set at the factory for imagePRESS Server P400 V1.0.
If you need to replace the motherboard, unlock the HDD first, so that new motherboard can access the data in the storage.
1. Obtain the Fiery Password
To unlock the HDD, go to WebTools and enter the Fiery password.
NOTE:
User data encryption passphrase may have been changed by the Administrator.
If the User Data Encryption passphrase has not been changed, then obtain the default Fiery password using the procedure in
"How to obtain the Fiery password" on page
If the User Data Encryption passphrase has been changed, then obtain the passphrase from the Administrator.
2. Unlock the Storage
If an error message is displayed on the Fiery Ticker indicating that the imagePRESS Server is locked, do the following:
1. Start a web browser.
2. Enter the URL or IP address shown in the error message.
3. Enter WebTools, Configure > User Data Encryption menu, enter the Fiery password/passphrase to unlock Hdd, then
click [Submit].
NOTE:
Ask the site administrator for the passphrase used for the Fiery User Data Encryption. You have five attempts to enter the
passphrase. If you fail five times, you can select either of the following:
• Reset all user data: The imagePRESS Server will be reset to the factory default. The imagePRESS Server will be reinstalled
from the recovery partition. All the user data will be erased and the custom settings will be reset to default. Selecting this
option will automatically start the recovery process. For more information, (see
• Reboot Fiery: The imagePRESS Server will reboot and you are allowed to enter the passphrase another five times.
After unlocking HDD, restart imagePRESS Server.
66.
9.
9
"Installing system software" on page
1. Introduction
46).