Husqvarna AUTOMOWER 535 AWD Operator's Manual page 36

Message Cause
Lifted
A blockage has activated the lift senors and
caused the product to stop.
Slope too steep Mower stopped because the slope is too
steep.
Alarm! Mower switch-
The alarm was activated because the prod-
ed off
uct was switched OFF.
Alarm! Mower stop-
The alarm was activated because the prod-
ped uct was stopped.
Alarm! Mower was The alarm was activated because the prod-
moved
uct was moved.
Alarm! Outside geo- The alarm was activated because the mower
fence
was outside its GeoFence.
Electronic problem
Temporary electronic or firmware related is-
sue.
Loop sensor problem
Charging system
problem
Tilt sensor problem
Temporary problem
STOP button prob-
lem
Ultrasonic problem
GPS navigation prob-
lem
Angular sensor prob-
lem
Switch cord problem
Invalid sub-device
combination
Invalid system config-
uration
Lift sensor problem
Collision sensor
problem
Temporary battery Temporary battery or firmware related issue.
problem
Battery problem
36 - Troubleshooting
Action
Remove the product from the blockage. If the
problem remains it requires action by author-
ized service technician.
Change the installation of the boundary wire
to exclude this steep part of the work area.
To examine where to put the boun-
Refer to
dary wire on page 12 .
Adjust the security level in the
Security (Bluetooth
menu, refer to
page 24 .
Adjust the theft protection area (GeoFence)
Automower Connect menu.
in the
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
Restart the product.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
1427 - 006 - 25.11.2021
Security
®
only) on