Husqvarna AUTOMOWER 535 AWD Operator's Manual page 35

Message Cause
Wrong PIN code
Wrong PIN code has been entered. Five at-
tempts are permitted, and the product is then
blocked for a period of time.
Empty battery
The product cannot find the charging station.
The battery is spent.
The charging station's antenna is defective.
Slipped
The product is caught in something and has
been slipping.
The work area includes a steep slope.
The guide wire is not installed correctly in a
slope.
Wheel motor overloa- The product is caught in something.
ded
Charging station
The contact between the charging strips and
blocked contact strips may be poor and the product
has made a number of attempts to charge.
An object causes a blockage and the product
cannot enter the charging station.
The baseplate is tilted or bent.
Stuck in charging sta- The product slips on the baseplate.
tion
There is an object in the way of the product
preventing it from leaving the charging sta-
tion.
Upside down
The product is leaning too much or has
turned over.
Mower tilted
The product is tilted more than the permitted
slope.
1427 - 006 - 25.11.2021
Action
Enter the correct PIN code. If the PIN code is
incorrect, use the link in the app to send the
PIN code to your registered e-mail address.
If you have not registered the e-mail address,
contact your local Husqvarna representative.
Change the position of the guide wire. Refer
To install the guide wire on page 18 .
to
Check the installation settings about how to
find the charging station. Refer to
charging station on page 22 .
Replace the battery. Refer to
page 33 .
Check if the indicator lamp in the charging
LED indicator of
station flashes red. Refer to
the charging station on page 40 .
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the
product.
Maximum guaranteed slope is 70%. Steeper
slopes should be isolated. Refer to
the boundary wire in a slope on page 13 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
the guide wire on page 18 .
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the
product.
Put the product in the charging station and
check that the charging strips and contact
strips make good contact. Clean the contact
and charging plates.
Remove the object.
Make sure that the baseplate is put on level
ground.
Clean the baseplate.
Remove the object.
Turn the product the right way up.
Move the product to a flat area.
Troubleshooting - 35
To find the
Battery on
To put
To install