Husqvarna AUTOMOWER 535 AWD Operator's Manual page 13

E
C
A
• Put the boundary wire around all of the work area
(A). Adapt the distance between the boundary wire
and obstacles.
• Put the boundary wire 35 cm / 14 in. (B) from an
obstacle that is more than 5 cm / 2 in. high.
• Put the boundary wire 30 cm / 12 in. (C) from an
obstacle that is 1-5 cm / 0.4-2 in. high.
30 cm / 12
• Put the boundary wire 10 cm / 4 in. (D) from an
obstacle that is less than 1 cm / 0.4 in. high.
1427 - 006 - 25.11.2021
D
F
B
"
> 5 cm / 2
"
35 cm /14
"
"
1-5 cm / 0.4 - 2
10 cm / 4
• If you have a paving stone path that is in level with
the lawn, put the boundary wire below the paving
stone.
Note:
If the paving stone is minimum 30 cm / 12
in. wide, use the factory setting for the
Wire function to cut all the grass adjacent to the
Drive Past Wire on page
paving stone. Refer to
24 .
• If you make an island, put the boundary wire that
runs to and from the island near together (E). Put
the wires in the same stake. Refer to
island on page 14 .
• Make an eyelet (F) where the guide wire is to be
connected to the boundary wire.
3.4.4 To examine how to put the boundary
wire around the charging station
• Husqvarna recommends to put the boundary wires
straight out from the charging station (A).
A
B
• If it is necessary you can put the boundary wire
below the charging station in an angle (B).
Note:
Do not put the boundary wire too far below the
charging station. The product can find it hard to find and
enter the charging station.
3.4.4.1 To put the boundary wire in a slope
The product can operate in 70% slopes. Slopes that are
more than 70% must be isolated with the boundary wire.
"
"
max 1 cm / 0.4
Drive Past
To make an
Installation - 13