Husqvarna AUTOMOWER 535 AWD Operator's Manual page 38

Message Cause
Limited cutting height The cutting height adjustment cannot move.
Unexpected cutting
height
Cutting height prob-
lem, drive
Cutting height
blocked
Cutting height prob-
lem
No power in charging
Wrong or faulty power supply unit.
station
Power failure.
No contact between the contact plates and
the charging plates.
Cutting system imbal-
Too few or too many blades.
ance
Weak GPS signal
The sky is obstructed in large parts of the
work area.
Collision sensor
A blockage has caused the product to stop.
problem, front/rear
Collision
The body of the product cannot move freely
around the chassis.
The body of the product is not installed cor-
rectly in the rubber dampers.
38 - Troubleshooting
Action
Examine the cutting height adjustment and
remove grass and other unwanted material.
If the problem remains, the message re-
quires action by authorized service techni-
cian.
Examine the power supply. If it is necessary,
replace the power supply.
Find and rectify the cause of the power fail-
ure.
Make sure that the charging plates and the
contact plates are connected.
Examine the blades on the blade disc.
If possible, remove obstructing objects.
Disable the GPS navigation function and use
the lawn coverage function instead. Refer to
Lawn coverage on page 23 .
Remove the product from the blockage and
examine the cause of the stop.
Remove dirt and unwanted material between
the chassis and the body to make sure that
the body of the product can move freely
around the chassis.
Make sure that the rubber dampers are at-
tached correctly in the body of the product
and in the chassis. If the problem remains,
the message requires action by authorized
service technician.
1427 - 006 - 25.11.2021