Husqvarna AUTOMOWER 535 AWD Operator's Manual page 22

Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
the Schedule settings.
Model Approximate operation capaci-
2
ty, m
®
Automower 535 146 / 175
AWD
2
Example: A lawn of 500 m / 600 yd
®
Automower 535 AWD.
2
500 m / 146 ≈ 3.5 h.
2
600 yd / 175 ≈ 3.5 h.
Days / week h / day
7 3.5
3.13.2 Cutting height
3.13.2.1 Adjust the cutting height
The cutting height can be varied from MIN (3 cm / 1.2
in.) to MAX (7 cm / 2.8 in.).
Note:
During the first week after a new installation, the
cutting height must be set to MAX to avoid damaging the
loop wire. After this, the cutting height can be lowered
step by step every second week until the desired cutting
height has been reached.
3.13.2.2 TargetHeight
Use the TargetHeight function to lower the cutting height
from MAX to the specified cutting height gradually during
10 days. If you change the cutting height manually
during this time it will disable the TargetHeight function.
3.13.3 Operation
Operation you can change the operation settings of
In
the product.
3.13.3.1 Object avoidance
Object avoidance function makes the product
The
decrease speed when it comes near an obstacle, and
then it turns away from the obstacle.
22 - Installation
2
/ yd / h
2
, cut with an
Schedule settings
10:00 - 13:30 / 10 am -
1.30 pm
Note:
This can cause that the grass is not cut around
the obstacle. This function can cause the product to not
cut high grass satisfactorily.
3.13.3.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
When using Weather timer , it is recommended
to make as much operating time as possible available
for Weather timer . Do not restrict the schedule more
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
Weather timer selects if the product will
and then
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
3.13.3.3 ECO mode
ECO mode is activated, it switches off the signal in the
If
boundary loop, the guide wire and the charging station,
when the product is parked or is charging.
Note:
Use ECO mode to save energy and avoid
interference with other equipment, for example hearing
loops or garage doors.
Note:
To start the product manually in the work area,
push the STOP button before you remove the product
from the charging station. If not, the product cannot be
started in the work area.
3.13.4 Installation
In Installation you can change the installation settings of
the product.
3.13.4.1 To find the charging station
The product can be set to search for the charging station
in 3 methods:
Charging station signal
•
Follow boundary wire
•
• Follow guide wire
Reset of all user
1427 - 006 - 25.11.2021