Troubleshooting - Heinner HC-H273WA+ Manual

www.heinner.com

Troubleshooting

Caution! Before troubleshooting, disconnect the power supply. Only a qualified
electrician of competent person must do the troubleshooting that is not in this
manual.
Important! There are some sounds during normal use (compressor, refrigerant
circulation).
Problem
Appliance does not
work
The food is too
warm
Appliance cools too
much
Unusual noises
Water on the floor
Side panel is hot
Possible Cause
Temperature regulation knob
is set at number "0"
Mains plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly
adjusted.
Door was open for
extended period
A large quantity of warm food
was placed in the appliance
within the last 24 hours
The appliance is near a heat
source
Temperature is set too cold
Appliance is not level
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
Appliance or the wall
Water drain hole is blocked
Condenser is inside the panel
Solution
Set the knob at other number
to switch on the appliance.
Insert mains plug
Check fuse, replace
necessary
Mains malfunctions are to be
corrected by an electrician.
Please look in the initial
Temperature Setting section
an Open the door only as long as
necessary
Turn the temperature
regulation to a colder setting
temporarily.
Please look in the installation
location section
Turn the temperature
regulation knob to a warmer
setting temporarily
Re-adjust the feet
Move the appliance slightly
If necessary, carefully bend
the component out of the
way.
See the Cleaning section
It's normal
if
17