Accessory Installation - Gallet GALMIX 329 Instruction Manual

INSTRUCTION FOR USE
Remove all packing material and take out the hand blender and the accessories. Remove all
possible adhesion foils, stick-on labels or paper from the appliance. Before the first use, wash the
parts that will be in contact with food in hot water with a detergent, rinse thoroughly with clean water
and wipe till dry, or let dry (see CLEANING AND MAINTENANCE). Put the hand blender with the
selected accessories on a flat, stable, smooth and clean work surface at the height of at least 85
cm, out of reach of children and incapacitated people (see par. SAFETy WARNING). Make sure
that the power cord is not damaged and that it does not lead through any sharp or hot surfaces.
Plug power supply fork A4 to the electric power and control light A2 will come on. Choose the
amount of the processed food so that the maximum volume of the containers marked with the
gauge line is not exceeded. Bigger amount of processed food has to be divided into several
doses and the volume of the containers has to be checked regularly. Any time you work with the
appliance, do not forget to put an anti-slip base under container F. We recommend stopping work
from time to time, switching off the appliance and removing possible food that was stuck onto the
blending/beating adapter, the sickle-shaped knife, graters, containers or the lid (see SAFETy
WARNING). Food preparation (processing) times are only approximate, they depend on the
amount, the kind and the quality of used ingredients and they range in seconds to minutes (see the
table). After finishing work, disconnect the appliance from power supply by taking the connector of
power cord A4 out of the electric socket. Container D is suitable for use in a microwave oven.
Switch (A1)
Start the drive by pushing the switch (the motor runs only for the time when the
switch is pushed and at the output set by the electric regulation).
Electronic revolutions regulation (A3)
It enables setting optimum revolutions for the selected chopping, blending,
mixing, beating, cutting and grating adapter. By turning the regulator from
- (MIN) to + (MAX) you can continuously change the speed of the motor
revolutions (Fig. 2).

ACCESSORy INSTALLATION

Attaching and removing the propulsion unit (A)
Attach the propulsion unit A on the relevant head/lid
by sliding it into its connecting opening and turning
it part way (see pic. 3). Remove the attachment
reversely.
Nasadenie a sňatie šľahacieho nadstavca (C
Hriadeľ šľahacej metličky C zasuňte do prevodovky
C1, potom nasuňte prevodovku na pohonnú jednotku
A a pootočením upevnite (obr. 3). Snímte ho
opačným spôsobom.
4
Mounting and removal of lid (E3)
Put the lid onto the container E3 so that the lugs on its edge snap into
the moulded holes in the container and secure the lid by clockwise
movement to the maximum position (Fig. 4). You can remove the lid from
the container in the opposite direction.
3
, C1)
a,b
35 / 51
ENG
2