Sony DHC-NXM4D Operating Instructions Manual page 36

x DISTANCE (DHC-NXM4D only)
The default distance setting for the speakers in
relation to the listening position is shown below.
Be sure to change the value in the Setup Display
when you move the speakers.
When you set the distance using the "QUICK
SETUP" (page 13), the settings are
automatically displayed.
Any items that are set to "NONE" in the "SIZE"
setting will not appear.
The default settings are underlined.
FRONT
1.6m
CENTER
1.6m
SURROUND
1.6m
Notes
• When adjusting speakers, the sound may cut off for a
moment.
• If each of the front and surround speakers are not
placed at an equal distance from your listening
position, set the distance of the closest speaker.
• Do not place the surround speakers farther away
from your listening position than the front speakers.
36 GB
1.6m
1.6m 1.6m
1.6m 1.6m
Front speaker distance from the
listening position can be set in
0.2 meter increments from 1.0 to
7.0 meters.
Center speaker distance can be
moved up to 1.6 meters closer to
the listening position, from the
front speakers in 0.2 meter
increments.
Surround speaker distance can be
moved up to 4.6 meters closer to
the listening position, from the
front speakers, in 0.2 meter
increments.
Adjusting the speaker volume
and level
For DHC-NXM4D
1
Press DVD SETUP in stop mode.
The Setup Display appears.
2
Press M or m repeatedly to select
"SPEAKER SETUP", then press
ENTER.
3
Press M or m repeatedly to select
"TEST TONE", then press ENTER.
4
Press M or m repeatedly to select "ON",
then press ENTER.
You will hear the test tone from each
speaker in sequence.
5
Press M/m/</, repeatedly to adjust
the value of "LEVEL" and "BALANCE"
from your listening position.
The test tone is emitted from the selected
speaker.
6
Press ENTER when you finish
adjusting.
7
Press M or m repeatedly to select
"TEST TONE", then press ENTER.
8
Press M or m repeatedly to select
"OFF", then press ENTER.
Tip
To adjust the balance or the level without listening to
the test tone, select "BALANCE" or "LEVEL" in step
3 and press ENTER, then adjust the balance or level
using M or m and press ENTER.
For DHC-NXM2D
1
Press DVD SETUP in stop mode.
The Setup Display appears.
2
Press M or m repeatedly to select
"SPEAKER SETUP", then press
ENTER.
3
Press M or m repeatedly to select
"LEVEL", "BALANCE" or "LFE", then
press ENTER.
4
Press M or m repeatedly to adjust the
level or balance or select a setting,
then press ENTER.