Host Setup; Host - Planet Networking & Communication ICA-E3550V User Manual

3.5 Host Setup

The "Host Setup" section allows the administrator to define the name of the camera and preferred user
interface language.

3.5.1 Host

Parameters
Host Name Host Name is used to identify the camera by a DHCP server. In some
networks with very strict security policy, it is required that all the network
devices should have their host name, and when the devices attempt to
access the network by requesting an IP address from a DHCP server, the
DHCP server would check if the host name is among the allowed devices.
On this page, it is possible to edit the Host Name. To actually include the
Host Name in DHCP discovery packet sent from a camera, please go to IP
Settings and make sure the device is in Dynamic IP Address mode and
"Use host name" is checked.
Language Language selection under Host has the same purpose as the one on the
login page of Web Configuration.
Camera Camera Name is used to identify the device by Video Management
Name System or by Software Tools. Usually, upon installation of the camera, the
actual installation location is used as an easy-to-remember Camera
Name, such as "Front Gate" or "Elevator 1". In many cases the VMS is
able to modify the Camera Name directly via its own user interface without
needing to access Web Configuration.
After changing any of the items above, press Apply to save the changes. The Reset button undoes
the changes that had just been made but not Applied yet.
5 Mega-pixel Bullet IR PoE IP Camera
Description
36
ICA-E3550V