Table of Contents
Advertisement
Audio level adjusted to the maximum:
This volume control appears on the user interface only when the Audio-in function of the camera has
been "Enabled" under the Setup page.
The digital output controls appear on the Live View page of the cameras with digital input/output function.
The controls allow users to manually trigger a DO device.
- Select DO Port
Each DO port is controlled separately. For cameras with more than one DO port, select the DO port and
press
to set the output power level to high or
setting the port to a high power level "activates" the DO device and setting the port to a low power level
"deactivates" the DO device. For example, if an alarm is set as DO1 and
continuously sound until
3.4 Configuration
To configure any of the camera settings, go to the Setup menu by pressing the following button on the
Live View page:
- Go to
Several items on the Setup page are divided into groups, such as Network, IP Settings, etc. You can
expand the groups to see the sub-items by pressing the [+] button.
The following chapters of this manual explain each Setup item separately. The chapters are listed in
the same order as the list of Setup menu items.
is pressed to deactivate the device.
The left side of the Setup page contains the list of Setup items.
The exact content of the menu list varies for each
camera, depending on the actual capabilities of each
camera. This manual, however, is designed to explain
all the possible functions.
35
5 Mega-pixel Bullet IR PoE IP Camera
to set the output power level to low. Consequently,
ICA-E3550V
is pressed, the alarm will
Advertisement
Table of Contents
