Assembling The Lawnmower; Assembling The Handle; Before Starting The Lawnmower; Adding Oil - Fieldmann FZR 4608 B Manual

EN 8 Assembling the lawnmower | Before starting the lawnmower

5. ASSEMBLING THE LAWNMOWER

IMPORTANT INFORMATION: Carefully unfold the lawnmower handle, being careful not to pinch or
damage the lawnmower's control cables.

ASSEMBLING THE HANDLE

1. Insert the bottom part of the handle (Fig. 2 – point 1) into the respective hole on the lawnmower (see arrow)
and secure in place with 4 screws – two screws on each side of the handle.
2. Attach the top part of the handle (Fig. 2 – point 2) to the bottom part of the handle using the included screws
with wing nuts (Fig.2 – point 3).

6. BEFORE STARTING THE LAWNMOWER

ADDING OIL

The lawnmower is supplied without motor oil. Before first start up, add motor oil SAE30 or
15W-40 (approx 600 ml) according to the following instructions.
1. When pouring in the oil, place the lawnmower on a level
surface.
2. Pull the cap with the oil dipstick out of the oil refill hole
(Fig. 3).
3. After adding oil, put the dipstick back into the hole and
tighten it.
4. The oil level must be between the upper (MAX)
and lower (MIN) limit (Fig. 3).
Caution! DO NOT OVERFILL the oil tank, otherwise
a large amount of smoke will come out of the exhaust
when the lawnmower is started up.
Fig. 2
Fig. 3
FZR 4608 B