Assembling The Lawnmower - Fieldmann FZR 4616 BES Manual

EN 8

Assembling the lawnmower

5. ASSEMBLING THE LAWNMOWER
IMPORTANT INFORMATION: Carefully unfold the lawnmower handle, being careful not to pinch or
damage the lawnmower's control cables.
1. ASSEMBLING THE HANDLE
1. Insert the bottom part of the handle (Fig. 2 – point 1) into the respective hole on the lawnmower (see arrow)
and secure in place with 4 screws – two screws on each side of the handle.
2. Attach the top part of the handle (Fig. 2 – point 2) to the bottom part of the handle using the included screws
with the quick coupler and wing nuts (Fig.2 – point 3).
IMPORTANT NOTICE: After loosening the quick coupler, it is possible to comfortably adjust the height
of the handle and to select the most comfortable work position.
2. INSTALLING THE HANDLE PANEL
Attach the plastic handle panel using the included screws (fi g. 3). The screws used for fastening the panel at the
top part are shorter than the screws intended for fastening at the bottom part.
Fig. 2
Fig. 3
FZR 4616 BES