Yamaha RAPTOR YFM700RF 2015 Service Manual page 77

1. Parking brake cable
2. Radiator fan motor coupler
3. Ignition coil leads
4. Headlight lead (right)
5. Rectifier/regulator lead
6. Reverse control cable
7. Throttle cable
8. Handlebar switch lead
9. Clutch switch lead
10. Main switch lead
11. Front brake light switch lead
12. Coolant temperature sensor lead
13. Intake air pressure sensor lead
14. Fuel injector lead
15. Intake air pressure sensor
16. Throttle position sensor
17. Throttle position sensor lead
18. Air induction system hose (air filter case joint to air
cut-off valve)
19. Air filter case joint
20. Intake air temperature sensor
21. Intake air temperature sensor lead
22. Crankcase breather hose
23. Negative battery lead
24. Lean angle sensor
25. Fuel pump
26. Fuel hose
27. Fuel pump lead
28. Clutch cable
29. Radiator fan motor breather hose
30. Indicator light assembly coupler
31. Indicator light assembly lead
32. Indicator light assembly
A. Route the reverse control cable to the front of the
wire harness.
B. Route the air induction system hose (air filter case
joint to air cut-off valve) over the air filter case joint.
C. Leave some slack in the intake air temperature
sensor lead in the area shown in the illustration.
D. Route the crankcase breather hose between the
battery box and the air filter joint, and under the
wire harness.
E. Route the negative battery lead between the lean
angle sensor and the wire harness.
F. Route the negative battery lead connector as
shown in the illustration.
G. Connect the AC magneto lead, sub-wire harness,
rear brake light switch lead, and speed sensor lead
in front of the lean angle sensor.
H. Route the fuel pump lead under the fuel hose.
I. Make sure to position the throttle cable protector
as shown in the illustration.
J. Insert the projection on the indicator light assembly
coupler into the hole in the front fender.
K. Fasten the radiator fan motor breather hose with
the holder on the front fender, and then insert the
end of the hose into the hole in the fender.
L. Make sure that the indicator light assembly lead is
not routed on top of the rib on the front fender.
M. Fasten the indicator light assembly lead with the
holder on the front fender.
N. Fasten the indicator light assembly lead with the
holder on the radiator grill.
O. Fasten the leads with the holder at the section
before the intake air temperature sensor lead
branches off from the other leads. Face the catch
of the holder forward.
P. Point the open ends of the holder to the right.
2-48
CABLE ROUTING