Yamaha RAPTOR YFM700RF 2015 Service Manual page 49

Item
Rear brake caliper union bolt
Parking brake case bolt
Rear brake master bolt
Rear brake master cylinder union
bolt
Rear brake master cylinder ad-
justing bolt
Parking brake adjusting bolt lock-
nut
Rear brake disc mounting bolt
Brake hose holder bolt
Front guard bolt
Front panel bolt
Front fender bolt
Front fender nut
Headlight bolt
Rear fender bolt
Rear fender bolt
Rear fender nut
Tail/brake light assembly bolt
Battery holding bracket bolt
Air filter case bolt
Rear carrier bar bolt
ECU bolt
Lean angle sensor nut
TIP
1. Apply a rust preventive lubricant to the threads on both sides of the rear axle and to the wheel hub
surfaces that contact the rear axle washers.
2. Tighten the rear axle nuts 200 Nm (20.0 m·kg, 145 ft·lb).
3. Loosen the rear axle nuts completely.
4. Retighten the rear axle nuts 200 Nm (20.0 m·kg, 145 ft·lb). Do not loosen the axle nuts after tighten-
ing them.
If an axle nut slot is not aligned with the cotter pin hole on either side of the axle, further tighten the
axle nut until a slot is aligned with the hole.
Thread
Q'ty
size
M10 1 30 Nm (3 m·kg, 22 ft·lb)
M8 2 22 Nm (2.2 m·kg, 16 ft·lb)
M6 2 20 Nm (2 m·kg, 14 ft·lb)
M10 1 30 Nm (3 m·kg, 22 ft·lb)
M8 1 17 Nm (1.7 m·kg, 12 ft·lb)
M6 1 16 Nm (1.6 m·kg, 11 ft·lb)
M8 4 33 Nm (3.3 m·kg, 24 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M8 4 12 Nm (1.2 m·kg, 8.7 ft·lb)
M6 2 4 Nm (0.4 m·kg, 2.9 ft·lb)
M6 3 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 9 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 4 7 Nm (0.7 m·kg, 5.1 ft·lb)
M8 4 32 Nm (3.2 m·kg, 23 ft·lb)
M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M4 2 2 Nm (0.2 m·kg, 1.4 ft·lb)
2-20
TIGHTENING TORQUES
Tightening torque Remarks
LT
LT
LT