Plextor PX-760 Installation And User Manual page 93

Rear Panel, PX-760A Internal ATAPI Drive
Power Supply
Power
Consumption
IDE Interface
Connector
Analog Audio
Output
Connector
Digital Audio
Output
Connector
Mode Jumper
Typical standby current
Typical DVD read
current (DVD 16X)
Typical CD read current
(CD 48X)
Typical DVD write
current (DVD+R 18X)
Typical write current
(CD-R 48X)
Typical pause current
Peak current
Average 22.2 W for DVD read/write
IDE bus, 40-pin flat ribbon type. Interface complies
with ATA/ATAPI-5. Must use 80-conductor IDE/ATA
cable.
NOTE: Although the PX-760A will operate with a 40-
conductor cable, it may not be able to write at 18X
unless an 80-conductor IDE/ATA cable is used.
Maximum total cable length cannot exceed 18 in
(45.7 cm).
Not used
Digital audio output for input to SPDIF or Digital-In
input
Master (default), slave, cable select (CSEL)
Appendix A: PX-760 Specifications
DC +12V,
±10%
100 mA
1.4 A
1.4 A
1.4 A
1.4 A
1.0 A
2.3 A
PX-760 Installation and Users Manual
DC +5V,
±5%
230 mA
700 mA
750 mA
1.4 A
800 mA
700 mA
1.7 A
85