Plextor PX-760 Installation And User Manual page 52

Section 3. Installing the PX-760SA Internal SATA Drive
4. Determine if you must install mounting rails on the sides of your
drive. To do so, insert the drive into the open bay. If the drive fits
tightly with little or no clearance on either side of the drive, you will
not have to use mounting rails. The drive can be mounted directly
into your computer. Go to step 6.
NOTE: Plextor does not provide rails. If you need rails, you can
obtain them from the computer manufacturer or from a computer
supply retail or mail-order store.
5. If you must use mounting rails, fasten the rails to the lower pair of
holes as shown in the illustration below. (In some instances, you may
need to fasten the rails to the upper set of holes.) After fastening the
rails, check their positioning by sliding the drive into the bay before
you mount the drive or connect any cables.
CAUTION: Be sure not to mistake the inner and outer face of the rail
when attaching. Typically, the smooth side of the rail faces away from
the drive's chassis.
Figure 23: Installing mounting rails (if needed)
44
PX-760 Installation and Users Manual