Laser Technology IMPULSE LR User Manual page 45

T M
AKING A ULTIPLE
4. Press Fire to enter the CUM subprocedure.
Impulse 100: The next display is a series of
dashes, with two arrows flashing in the right
corner. The instrument is now ready to take the
first measurement.
Impulse 200: SEL shows in the numeric
display area, and HD flashes just to the left of
MULTI.
At this point, you can select whether to take all
of the measurements as horizontal distances or
slope distances. You can toggle between the
two at any time.
Horizontal distance is already selected, as
shown by the flashing HD indicator. To use HD
measurements, then, simply
Page 37
M
EASUREMENT
Electronic Copy of LTI's Impulse User's Manual 8
press Forward to move to the next display.
To select SD measurements, press Fire to start
SD flashing. Then press Forward to move to the
next display.
The next display is a series of dashes, with two
arrows flashing in the right corner. The
instrument is now ready to take the first
measurement.
5. Aim to a target and press Fire. If the aiming dot
is off on the red dot scope, the first press turns
it on, and you must press Fire again to fire the
laser.
6. At this point, you have two options.
If you are dissatisfied with the measurement for
some reason, repeat step 5 to retake the
measurement.
th Edition © October 1998