Setting The Scope Dot Intensity; Setting The Measurementu; Nits - Laser Technology IMPULSE LR User Manual

T B M
AKING A ASIC

Setting the Scope Dot Intensity

The optional red dot sighting scope has six intensity
settings which vary from bright to off. Adjust the red
dot brightness by pressing the Forward2 button
repeatedly until the desired intensity is achieved.
Setting the Measurement Units
The Impulse will express measurements either in
English units or in metric units. You select the units
by accessing the SYS option. Here is the
procedure:
1. Use Forward and Back as needed to display
the SYS indicator.
2. Press Fire to select the SYS option.
3. Press Forward repeatedly until the UNITS
indicator at the bottom center of the display
screen begins flashing, and SEL shows in the
numeric display area.
Page 23
EASUREMENT
Electronic Copy of LTI's Impulse User's Manual 8
4. Press Fire to toggle between the F (feet) and M
(meters) indicators.
5. Press Forward to select F or M. The D
(degrees) or G (gradient) indicator begins
flashing.
6. Next, press Fire to toggle between D and G.
7. Press Forward to select D or G. The % indicator
flashes, and OFF shows in the numeric display.
8. If you wish to turn on Percent Slope, press Fire.
9. Press Back twice to accept the new settings
and back out to the main display.
Note: Changing your range measurement units will
affect several values you may have stored in
memory. The height pivot offset, range offset, and
gate values will be
th Edition © October 1998