Laser Technology IMPULSE LR User Manual page 43

T M
AKING A ULTIPLE
Impulse 200: SEL shows in the numeric
display area, and HD flashes just to the left of
MULTI.
At this point, you must select whether to take all
of the measurements as horizontal distances or
slope distances. Horizontal distance is already
selected, as shown by the flashing HD
indicator. To use HD measurements, then,
simply press Forward to move to the next
display.
To select SD measurements, press Fire to start
SD flashing. Then press Forward to move to the
next display.
The next display is a series of dashes, with two
arrows flashing in the right corner. The
instrument is now ready to accept the set point.
Page 35
M
EASUREMENT
Electronic Copy of LTI's Impulse User's Manual 8
4. To set the point by laser, aim to a suitable
target and press Fire. If the aiming dot is off on
the red dot scope, the first press turns it on, and
you must press Fire again to measure the
target.
To set the point manually, invoke the Impulse
edit mode. See The Edit Mode for more
information.
Note: An edited set point cannot exceed
±999.99 feet or meters, but a set point
measured by the laser can extend to the full
range of the instrument.
5. Press Forward. The numeric display area
shows dashes, and the arrows turn off.
th Edition © October 1998